Somewhere in your renewal sheet there is a column with one percentage in it, and it was right the year you built the sheet. If your buildings sit in more than one province or state, that column is right in one market at most this year, and nothing on the sheet says which one.
The column got there honestly. A portfolio grows one building at a time, and the first few share a market, so the rules are one set, the figure is one number a year, and one column is the correct design. Then a building across a line comes in with its own number and its own calendar, and the sensible move is to keep the sheet that works and remember the exception. Nothing in that is careless. It is how most multi-market portfolios are run, right up to the year the exception grows an exception of its own.
The cost arrives in three shapes. The first is the right year with the wrong number: a guideline carried across a border it does not cross, so a notice in a capped market asks for more than that market allows, and in several markets a notice above the limit is not a slightly wrong letter but one the tenant can refuse and a tribunal can set aside. The second is the right number in the wrong year: the figure follows the period in which the increase takes effect, not the day the notice goes out, so an autumn notice for a January increase has to carry the coming year's figure, which in some markets publishes only weeks before the notice is due. The third is the right number for a unit the cap never reached, a newer building or a higher rent, where the ceiling you applied was never yours to apply.
The quietest cost is the increase that does not happen. When nobody can say for certain which figure applies to which building, the careful choice is to wait, and a building sits at last year's rent for a year it did not have to. Its mirror image is the market with no cap at all, which reads on the sheet as a market with no rules, when what it has is a notice floor and a frequency clock and nothing else to catch you.
None of these is a pricing problem. The number was always yours to set, inside the rule. They are record problems, and the record that is missing is a small one: which market, which period, which figure, and which source said so. That is a fact about a place and a year, and a sheet organized around leases has no natural home for it, which is why it lives in someone's memory until the year it does not.
A rent increase limit is a fact about a place and a year, never about your portfolio.
Handled differently, the figure is looked up once per market and per period, with its source, and attached to each lease by the date its increase takes effect, so the column disappears into the lease. The autumn notices for January carry the new year's figure because the schedule knows which year the increase lands in. A building the cap does not reach is marked as such once, not re-argued at every renewal. The market with no cap gets its notice floor and its clock instead of a blank. And the renewal sheet goes back to being what it was good at: a list of dates.
Scaalr carries a jurisdiction profile for each supported market and validates every scheduled increase against it, the cap or guideline, the frequency rule, and the notice floor checked when you set the increase and again before anything serves, with the prescribed form filled where the market has one and a manager's acknowledgment of the market's current rules before the first notice goes out. The figures themselves, 2026 and 2027 side by side with each market's notice floor, form, and official source, are in Rent Increase Limits for 2027: The Market-by-Market Table.
For the complete table of 2026 and 2027 figures, notice floors, and forms, see: Rent Increase Limits for 2027: The Market-by-Market Table.
Put one building on it first. $99 covers your first 50 units, Alex included. Cancel anytime.